Strain Path Dependent Dynamic Recrystallization and Its Resulted Material Flow and Microstructure Evolution of a Titanium Alloy

Changing strain path is an effective method to optimize the hot working process and improve microstructure and mechanical performance of titanium alloys. In this work, dynamic recrystallization (DRX) and its resulted material flow and microstructural behaviors in monotonic torsion (MT) and forward-reverse torsion (FRT) were comparatively explored by experimental and crystal plastic finite element simulation methods. The results indicate that both MT and FRT can induce discontinuous DRX (DDRX) and continuous DRX (CDRX). However, compared to MT where CDRX always prevails, FRT makes DDRX more important since it inhibits CDRX by recovering the lattice rotation during the reversal stage. Moreover, in FRT, the driving force and the grain boundary content for DDRX nucleation and bulging are relatively low at a small total strain. And the recovery of lattice rotation in FRT can also suppress CDRX. Therefore, DRX kinetics is obviously delayed at a smaller strain. As strain increases, both the stored energy for DDRX and the long-range misorientation gradient for CDRX are gradually greater, thus improve DRX kinetics. With these effects by DRX, although FRT exhibits a lower grain refinement degree at a smaller total strain compared to MT, it can make grain refinement degree rapidly rise and even close to that in MT at a greater strain. Also, FRT can obviously weaken the deformation texture by inducing extensive DDRX grains and recovering the lattice rotation of retained grains. In addition, the texture formed in forward stage and DRX delaying can result in a decrease in yield strength and softening rate in reversal stage, respectively, i.e., exhibiting remarkable Bauschinger effect, especially at a higher forward strain. These results can provide a basic guidance for designing the hot working process of titanium alloys to obtaining more refined microstructure and excellent properties of the components.