Obtaining Uniform High-Strength and Ductility of 2A12 Aluminum Alloy Cabin Components via Predeformation and Annular Channel Angular Extrusion

A 2A12 aluminum alloy component with uniform high-strength and ductility was developed via predeformation (one-pass repetitive upsetting extrusion) and annular channel angular extrusion (ACAE). Moreover, the microstructure evolution and age-hardening behavior were investigated. The results show that the upsetting-extrusion predeformation improved the cumulative strain of the component and refined the grain size, and that the second Al-Cu-Mg phases were obviously broken and refined, and that, especially, the distribution of the second phases along the extrusion direction was weakened. Thus, compared with directly ACAE-formed components, after the T6 heat treatment, the axial ultimate tensile strength (UTS) of the cabin increased from 476 to 484 MPa, and the elongation (EL) increased from 12.9% to 17.5%. The circumferential UTS increased from 426 to 482 MPa, and the EL increased from 9.24% to 16.8%. A large number of dislocations were introduced into the upsetting extrusion (UE) + ACAE method, which resulted in strain hardening and higher precipitation strengthening in the late artificial aging process. The finer and denser grains and s precipitates significantly enhanced the strength and ensured the good ductility of the alloy. It is suggested that the combination of predeformation and annular channel angular extrusion is an effective method for forming aluminum alloy cabin components with higher and more uniform mechanical properties.