Reference values and functional descriptions of transverse plane spinal dynamics during gait based on surface topography

Spinal dynamics during gait have been of interest in research for many decades. Based on respective previous investigations, the pelvis is generally expected to be maximally forward rotated on the side of the reference leg at the beginning of each gait cycle and to reach its maximum counterrotation approximately at the end of the reference leg's stance phase. The pelvic-upper-thoracic-spine coordination converges towards an anti-phase movement pattern in high velocities during ambulation. The vertebral bodies around the seventh thoracic vertebra are considered to be an area of transition during human ambulation where no or at least little rotary motion can be observed. The respective cranial and caudal vertebrae meanwhile are expected to rotate conversely around this spinal point of intersection. However, these previous assumptions are based on scarce existing research, whereby only isolated vertebrae have been analyzed contemporaneously. Due to huge methodological differences in data capturing approaches, the results are additionally hardly comparable to each other and involved measurement procedures are often not implementable in clinical routines. Furthermore, none of the above-mentioned methods provided reference data for spinal motion during gait based on an appropriate num-ber of healthy participants. Hence, the aim of this study was to present such reference data for spinal rotary motion of every vertebral body from C7 down to L4 and the pelvis derived from surface topographic back shape analyses in a cohort of 201 healthy participants walking on a treadmill at a given walking speed of 5 km/h. Additionally, the spine's functional movement behavior during gait should be described in the transverse plane based on data derived from this noninvasive, clinically suitable measurement approach and, in conclusion, the results shall be compared against those of previous research findings derived from other measurement tech-niques. Contrary to the previous functional understanding, the area of the mid-thoracic spine was found to demonstrate the largest amplitude of rotary motion of all investigated vertebrae and revealed an approximately counterrotated movement behavior compared to the rotary motion of the pelvis. In both directions, spinal rotation during gait seemed to be initiated by the pelvis. The overlying vertebrae followed in succession in the sense of an ongoing movement. Therefore, the point of intersection was not statically located in a specific anatomical section of the spine. Instead, it was found to be dynamic, ascending from one vertebra to the next from caudal to cranial in dependence of the pelvis's rotation initiation.