Estimation of the Center of Mass of GRACE-Type Gravity Satellites

One of the key constraints for the accelerometer of GRACE-type gravity satellites to accurately measure the non-gravitational accelerations acting on the satellite is that the center of mass of the satellite and the proof mass of the accelerometer should maintain a coincidence. In addition, the accuracy requirement is that the center of mass offset (CM-offset) in the three directions is less than 100 microns. Since the center of mass (CoM) of the satellite will change with the consumption of cold-gas fuel in the tanks, it is necessary to regularly carry out the CoM calibration maneuver. Firstly, the observation equations consisting of the accelerometer linear acceleration, angular acceleration, and the CM-offset vector are established in order to estimate the amount of CM-offset. Then, according to the estimated CM-offset, the satellite mass trim mechanisms are used to change the satellite's CoM, so that the satellite's CoM always approaches the proof mass of the accelerometer, with an accuracy of 100 mu m per axis. The CM-offset of the satellite of GRACE-FO is estimated by using the accelerometer, star camera, magnetic torquer, magnetometer, and the precision orbit data during the GRACE-C CM-offset calibration period on 1 February 2020. Four kinds of CM-offset results are obtained by four different angular accelerations as follows: the angular acceleration based on the attitude dynamics ("MTQ angular acceleration"), the accelerometer angular acceleration calibrated by MTQ, the accelerometer angular acceleration, and the angular acceleration calculated by the star camera. By comparing the four kinds of CM-offset results that are estimated by the four different methods, all four of the results are shown to have the same level of accuracy. Based on the accelerometer (calibrated) angular acceleration, the difference with the JPL result is 0.5 mu m, while the difference between the conventional method and the JPL result is 6.0 mu m. All four of the methods can achieve the requirement of 50 mu m accuracy and using four CM-offset estimation methods simultaneously can improve the integrity of the calibration results. Subsequently, the CM-offset results of GRACE-C since its launch are estimated here. The calibration algorithm that is proposed in this paper can be used as a reference in the calibration of gravity satellites carrying an accelerometer payload.