Anodic Behaviour of NixFeyCu5 and NixFeyCu20 in Potassium-Rich Naf-KF-AlF3-Al2O3 Melts
Meeting abstracts(2023)
摘要
Using inert anode technology to produce aluminium would substantially reduce the aluminium industry's carbon footprint. Replacing the Hall-Héroult process with an alternative process based on vertical electrode cell (VEC) design using inert anodes and wettable cathodes is a promising alternative, but must be developed to be economically viable at scale. Three material types have been explored as inert anodes: metals, cermets and ceramics. Metallic anodes have been widely studied for their attractive properties, such as superior mechanical strength, high electrical conductivity and ease of fabrication. Of metallic anodes, Cu-Al, Ni-Fe and Ni-Fe-Cu-based alloys are the most commonly examined alloy systems for anode applications. It is also necessary to use low-temperature melts during the electrolysis process to ensure that the anodes are not damaged. In NaF-KF-AlF 3 melts, increasing the KF content in the mixture would reduce the liquidus temperature and increase the alumina solubility in the melt. In this work, we examine the anodic behaviour of Ni x Fe y Cu 5 and Ni x Fe y Cu 20 electrodes, without prior surface treatment, in potassium-rich NaF-KF-AlF 3 melts at 770°C. The cryolite ratio (x NaF +x KF /x AlF3 ) and potassium ratio (x KF /x KF +x NaF ) of the melt used for the studies are 1.3 and 0.7, respectively. Electrochemical techniques such as chronopotentiometry, chronoamperometry and linear sweep voltammetry were performed to examine the anodic behaviour of these metallic anodes under an N 2 atmosphere. Figure 1 shows the steady-state anodic polarisation curves on Ni x Fe y Cu 5 and Ni x Fe y Cu 20 anodes before and after galvanostatic polarisation with an applied current density of 0.5 Acm -2 for 120 minutes. It can be noted that the anodic potential at the same current density is more for the polarised anode compared to the non-polarised in both cases. This is due to the formation of a stable oxide layer during the galvanostatic polarisation of the anode. Oxidation of the anode is expected instead of fluoridation when the melt is saturated with alumina. The stabilisation of anodic current can be seen between 1.9 and 2.4 V. This stabilisation corresponds to the passivation of anodes due to the oxide layer formation. A rapid increase in the current after 2.4 V is due to the oxygen evolution reaction. The anodic current density in the passive region is much lower in anodes with Cu 20%, meaning a more protective layer is formed. After the galvanostatic polarisation of the anode, anodes were examined using scanning electron microscopy to understand the oxide layer composition. Anodes performed stably in potassium-rich melts, and Cu content plays a vital role in the anode's performance. Figure 1. Stationary state polarisation curves of Ni x Fe y Cu 5 and Ni x Fe y Cu 20 anodes before and after the polarisation at 0.5 A cm -2 Figure 1
更多查看译文
关键词
ni<sub>x</sub>fe<sub>y</sub>cu<sub>5</sub>,potassium-rich,naf-kf-alf
AI 理解论文
溯源树
样例
![](https://originalfileserver.aminer.cn/sys/aminer/pubs/mrt_preview.jpeg)
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要