Impact of Electron Beam Melting process recycling on defects and microstructure of Ti-6Al-4V powders

Metal powders are used as the feedstock material during the Electron Beam Melting processes. The process involves using an electron beam as the energy source to produce intricate parts with complex shapes in a layer-by-layer production system. The electron beam is directed by information from an STL file, and the process takes place in a pre-heated chamber that is maintained under vacuum. Once the production cycle is complete, the process yields the desired components along with a certain amount of residual powders that were not melted.To improve process efficiency and reduce costs associated with powder atomization, it is feasible to reuse the excess powder for subsequent production cycles. Prior to starting a new cycle, the excess powder is initially sieved to ensure a more uniform powder batch, and subsequently, the sieved powder can be mixed with other virgin powder to decrease oxygen content.This study examines the microstructure and defects present in a batch of virgin powders produced through plasma atomization and a batch of powders that were reused five times and mixed with Ti-6Al-4V grade 23 (ELI powders) at each cycle. The ELI powders are characterized by a low oxygen content.The results of the analysis indicate a connection between the powder atomization process and the formation of porosities in virgin powders resulting from trapped gas, as well as surface irregularities, including the presence of satellites. With an increase in the number of reuses, there is a reduction in the number of satellites, potentially due to surface partial melting due to the pre-heating of the EBM chamber, leading to rougher surfaces on the recycled particles.The microstructure of virgin powders is predominantly characterized by a fine acicular α’ phase, known as martensitic, formed due to the rapid cooling rate during the atomization process. Conversely, recycled powder tends to exhibit a coarser grain microstructure due to lower cooling rates. However, it is common to observe particles with a microstructure similar to that of newly manufactured powders, indicating that each individual particle has undergone a distinct thermal history.