Constructing 1D/0D Sb2S3/Cd0.6Zn0.4S S-scheme heterojunction by vapor transport deposition and in-situ hydrothermal strategy towards photoelectrochemical water splitting

Antimony sulfide (Sb2S3) is widely used in photocatalysts and photovoltaic cells because of its abundant reserves, low toxicity, environmental friendliness, narrow band gap, and high light absorption capacity. Sb2S3 shows a quasi-one-dimensional structure composed of [Sb4S6]n nanoribbons, a lot of reported studies are focused on preparing Sb2S3 with [hk1] oriented dominant growth to improve the photogenerated carrier transport capacity of Sb2S3. However, there is relatively few research on the preparation of [hk1] oriented rod-like Sb2S3 by vapor transport deposition (VTD) method. In this work, the VTD method was used to prepare Sb2S3 with [hk1] oriented growth on the FTO substrate, and then composite with the ternary solid solution CdxZn1_xS. Finally, a novel Sb2S3/Cd0.6Zn0.4S S-scheme heterojunction with rod-like core-shell structure was successfully constructed, which could effectively improve the photoelectrochemical properties. Because the solid solution component x is adjustable, that is, CdxZn1_xS has continuously adjustable band gap width and energy level position, the Sb2S3/ CdxZn1_xS heterojunction type can be regulated from Type-II to S-scheme. Photoelectrochemical (PEC) tests indicated that the composite photoanode Sb2S3/Cd0.6Zn0.4S achieved a higher photocurrent density (2.54 mA center dot cm_ 2, 1.23 V vs. RHE), which is about 4.31 times that of pure Sb2S3 nanorod photoanode (0.59 mA center dot cm_ 2, 1.23 V vs. RHE).