Flow Boiling of Liquid n-Heptane in Microtube with Various Fuel Flow Rate: Experimental and Numerical Study

The evaporation of liquid hydrocarbon n-heptane is discussed in detail with experimentation and numerical techniques. A maximum wall temperature of 1050 K was reported during an experimental process with a two-phase flow that was stable and had a prominent meniscus at a small fuel flow rate (FFR) ≤ 10 µL/min. At medium to high FFR (30–70 µL/min), the flow field was unstable, with nucleating bubbles and liquid droplets inside the microtube and the maximum temperature recorded was 850 K for 70 µL/min. For the numerical model, the temperature of the wall was used as a boundary condition. Using the numerical model, the evaporative flux at the meniscus, pressure drop, pressure oscillation, and heat transfer coefficient (HTC) were investigated. A single peak in HTC was obtained at a low fuel flow rate, while multiple peaks were obtained for high FFR. At low FFR, the pressure peak was observed to be 102.4 KPa, whereas at high FFR, the pressure peak increased to 105.5 KPa. This shows a 2% increase in pressure peak with an increase in FFR. Similarly, when the FFR increased from 5 µL/min to 70 µL/min, the pressure drop increased from 500 Pa to 2800 Pa. The high amplitude of pressure drops and a high peak of HTC were found, which depend on the mass flow rate. The coefficient of variation for pressure drop depends mainly on the fuel flow rate.