Gas Injection Capacity of Slotted Liner and Perforation Completion in Underground Natural Gas Storage Reservoirs

The use of Horizontal wells is a common method of underground natural gas storage (UGS), but there is still a need to discuss whether they are more suitable for slotted liner or perforation completions. To address this issue, a numerical model is developed to predict the gas injection rate of horizontal wells while considering the skin factor. Here, a novel uncoupled iteration method is employed to determine the skin factor deriving from turbulence in each time step when the bottom hole pressure is fixed. The uncoupled method begins with an estimate of the initial gas injection rate, which is then used to calculate a turbulent skin factor. This turbulent skin factor is then used to update the gas injection rate, iterating continuously until convergence is achieved. The effects of slotted liner and perforation design parameters, formation damage, and injection pressure on the skin factor are analyzed. The main findings suggest that the error in the gas injection rate calculated by the non-coupled model compared with the coupled model is only 0.6%, yet it can reduce the number of sub-iterations to 1/10 of that required by the coupled model. Moreover, the uncoupled model can provide results within four steps, even when the convergence condition is 10(-14). The open area and perforation density play a significant role in determining the connection degree between the horizontal well and the reservoir, with a larger perforation density resulting in a negative skin factor. Perforations are more suitable than slotted liners for reservoirs with severe formation damage, and the difference in skin factor between the two can reach a value of 40.87 when the ratio of the damage zone's permeability to that of the normal reservoir zone is 0.05. It is easier to reduce turbulence damage in slotted liner completions than perforation completions, with the turbulence damage of the slotted liner being only 15.9% of that of the perforation. However, to avoid damage it is crucial to prevent the screen tube from being plugged in, as it might otherwise rise to three to ten times the original level. This study provides a theoretical basis and practical reference for the application of slotted liner and perforation method in UGS horizontal wells.