3-D Simulations of earthquakes rupture jumps: 1. Homogeneous pre-stress conditions

Observational and modelling studies indicate that earthquake ruptures can jump between fault sections as large as ∼3 and ∼5 km for compressional and extensional offsets, respectively. Here, we compare characteristics of the rupture jump process on parallel but offset fault sections from traditional 3-D dynamic rupture simulations governed by slip weakening friction using the finite element code, FaultMod, to those from quasi-dynamic simulations governed by rate- and state-dependent friction (rate-state friction) using the code RSQSim. These simulations use spatially uniform initial stresses. For a variety of measures the rupture renucleation position on the offset fault, the rate-state friction and slip weakening friction models produce very similar results. The principal difference is the additional occurrence of delayed rupture jumps that arise from the time- and stress-dependent nucleation that is characteristic of rate-state friction. For immediate rupture jumps, models with slip weakening friction span greater offsets than those with rate-state friction. However the jump distances are nearly identical when delayed rupture jumps are included in the comparisons. We propose that delayed rupture jumps are the likely mechanism for adjacent large-earthquake pairs and clusters. Based on the similarity of renucleation positions with both dynamic and quasi-dynamic models, we conclude that the renucleation positions for rupture initiation on the receiver fault (separated by less than ∼3 km from the source fault) are primarily controlled by static stress changes induced by slip on the initiating fault. However, in light of the slightly greater maximum jump distances (>3 km) seen with the dynamic slip weakening friction model, dynamic stress changes from seismic waves play an increasingly important role as offset distances increase.