Evaluation of the role of hatch-spacing variation in a lack-of-fusion defect prediction criterion for laser-based powder bed fusion processes

Lack of fusion (LOF) defects impact adversely on the mechanical properties of additively manufactured components produced via laser-based powder bed fusion. Following a stress-relieving heat treatment, the tensile properties and hardness of Ti6Al4V components were found to be negatively impacted by the presence of LOF defects. This work considers a geometrical-based inequality for the prediction of LOF defects. We critically evaluate an LOF criterion using both the experimentally and analytically obtained melt pool geometries. Experimentally, we determined melt pool dimensions by analysing a single-layer, multi-track deposition with oversized hatch spacing in order to establish depth and width from non-overlapping melt pools. Analytically, Rosenthal-based predictions of melt pool size (width and depth) are applied. To investigate LOF defects, we used hatch spacing as the main parameter variation to investigate defects while keeping all other controllable parameters unchanged. An original LOF criterion from the literature was found to be an adequate predictor of LOF defects when experimentally obtained melt pool geometry was used. Critically, however, the analytical expressions for melt pool geometry were found to be in error and this caused the LOF criterion to fail in predicting LOF defects in all cases where defects were observed experimentally. However, an adaptation to the LOF prediction criterion is proposed whereby it is recommended that a correction factor R_c^2=0.7 (or R_c=0.83 ) is used with the analytically derived melt pool geometry. Furthermore, this correction is extended into the laser power versus scanning speed operating space to give minimum (corrected) line energy for LOF avoidance in Ti6Al4V components.