Crystalline versus Amorphous Donor-Acceptor Blends: Influence of Layer Morphology on the Charge-Transfer Density of States

Organic small molecule solar cells are used as a test bed to investigate the influence of film morphology on the density of charge-transfer (CT) states. CT states are considered as precursors for charge generation and their energy as the upper limit for the open-circuit voltage in organic donor-acceptor solar cells. In this study the influence of morphology for two perylene donors [crystalline diindenoperylene (DIP) versus amorphous tetraphenyldibenzoperiflanthene (DBP)] with almost identical ionization energy is investigated. As acceptor material, the fullerene C-60 is used. By combining device measurements with optical and low-energy ultraviolet photoelectron spectroscopy, a comprehensive picture is obtained that describes how morphology and the connected density of states (DOS) affect device performance and the spectroscopic signature of CT states. Especially for the crystalline donor material DIP, strong exponential tail states reaching far into the gap are observed, which can be related to the presence of grain boundaries. A voltage-dependent filling of these states is identified as the origin of a blue shift of electroluminescence spectra with increasing applied voltage. Different approaches are compared to study the influence of static and dynamic disorder in the description of CT emission and absorption spectra of organic solar cells. Despite the fact that both donors yield almost identical CT energy (and, thus, the same open-circuit voltage) the Stokes shift between photocurrent and electroluminescence spectra and, concomitantly, the width of the CT DOS varies by more than a factor of 2. We discuss this observation in terms of the donor-acceptor reorganization energy as well as an additional line broadening by static disorder. Remarkably, the more crystalline donor DIP shows a significant deviation from a Marcus-type description, while this is not the case for the amorphous DBP. This highlights the importance of film morphology in organic solar cells.